Checking The Frame - Husqvarna 2014 FC 250 EU Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.42

Checking the frame

–
Check the chain sliding piece for wear.
» If the bottom edge of the chain pin is in line with or below the chain sliding piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
» If the chain sliding piece is loose:
–
Tighten the chain sliding piece.
Guideline
Screw, chain sliding piece
B01893-10
–
Check the chain guide for wear.
Info
Wear can be seen on the front of the chain guide.
» If the light part of the chain guide is worn:
–
Change the chain sliding piece.
401760-01
–
Check that the chain guide is firmly seated.
» If the chain guide is loose:
–
Tighten the chain guide.
Guideline
Remaining screws, chassis
B01928-01
Finishing work
–
Remove the motorcycle from the lift stand. (
x
–
Check the frame for cracking and deformation.
» If the frame exhibits cracking or deformation due to a mechanical impact:
–
Change the frame.
402015-01
x
x
x
Info
A frame that has been damaged due to a mechanical impact must
always be changed. Repair of the frame is not authorized by Husq-
varna.
M8 15 Nm
(11.1 lbf ft)
M6 10 Nm (7.4 lbf ft)
p. 32)
51