Service Schedule - Husqvarna 2014 FC 250 EU Owner's Manual

Table of Contents

Advertisement

9

SERVICE SCHEDULE

9.1
Service schedule
Once after 20 operating hours / Every 20 operating hours - corresponds to about 140 liters of fuel (37 US gal)
Every 10 operating hours - corresponds to about 70 liters of fuel (18.5 US gal) / after every race
Read out the fault memory using the Husqvarna diagnostics tool.
Check and charge the battery.
Check the front brake linings. (
Check the rear brake linings. (
Check the brake discs. (
Check the brake lines for damage and leakage.
Check the rear brake fluid level. (
Check the free travel of the foot brake lever. (
Check the frame and swingarm.
Check the swingarm bearing.
Check the shock absorber linkage.
Conduct a minor fork service.
Conduct a major fork service.
Service the shock absorber.
Check the tire condition. (
Check the tire air pressure. (
Check the wheel bearing for play.
Check the wheel hubs.
x
Check the rim run-out.
x
Check the spoke tension. (
Check the chain, rear sprocket, engine sprocket and chain guide. (
Check the chain tension. (
Grease all moving parts (e.g., hand lever, chain, ...) and check for smooth operation.
Check/rectify the fluid level of the hydraulic clutch. (
Check the front brake fluid level. (
Check the free travel of the hand brake lever. (
Check the steering head bearing play. (
Check the valve clearance.
Check the clutch.
x
Change the shaft seal rings of the water pump.
Change the engine oil and oil filter, clean the oil screen.
Check all hoses (e. g. fuel, cooling, bleeding, drainage) and sleeves for tearing, leaks and incorrect rout-
ing.
x
Check the antifreeze and coolant level. (
Check the cables for damage and routing without sharp bends.
Check that the throttle cables are undamaged, routed without sharp bends and set correctly.
Clean the air filter and air filter box.
Change the glass fiber yarn filling of the main silencer.
Check the screws and nuts for tightness.
Change the fuel screen.
x
Check the fuel pressure.
x
Check the idle.
x
Final check: Check the vehicle for roadworthiness and take a test ride.
Read out the fault memory using after the test ride the Husqvarna diagnostics tool.
Make the service entry in Husqvarna Dealer.net and in the service booklet.
Every 40 operating hours - corresponds to about 280 liters of fuel (74 US gal)
Every 30 operating hours - corresponds to about 210 liters of fuel (55.5 US gal)
Once after 1 operating hour - corresponds to about 7 liters of fuel (1.8 US gal)
x
p. 57)
p. 61)
p. 55)
p. 60)
p. 59)
x
x
x
x
x
x
p. 66)
p. 67)
x
p. 67)
p. 49)
p. 53)
p. 56)
p. 55)
p. 37)
x
x
p. 71)
(
p. 43)
x
x
x
(
p. 76)
x
p. 50)
(
p. 77)
x
x
(
p. 45)
x
x
x
24

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents