Husqvarna 2014 FC 250 EU Owner's Manual page 56

11 SERVICE WORK ON THE CHASSIS
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
C00444-10
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
Mount bleeding syringe
–
On the clutch slave cylinder, only release bleeder screw
is possible.
Info
B01899-10
Wash off overflowing or spilled brake fluid immediately with water.
Avoid contact between brake fluid and painted parts. Brake fluid attacks
paint.
Use only clean brake fluid from a sealed container.
–
Inject the liquid into the system until it escapes from openings
cylinder without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Tighten the bleeder screw and remove the bleeding syringe with the hose.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
C00445-10
1
.
2 3
with membrane .
4
with the appropriate hydraulic fluid.
p. 91)
4 on bleeder screw 5 with a suitable hose piece.
5
to the point where filling
6
of the master
4 mm (0.16 in)
54