Adding A Keyset Daughterboard Module; Outside Calls; Making An Outside Call; Answering An Outside Call - Samsung IDCS 28D User Manual
Keysets
Hide thumbs
Also See for IDCS 28D:
- User manual (44 pages) ,
- Quick reference manual (8 pages) ,
- User instructions (155 pages)
Table of Contents
Advertisement
ADDING A KEYSET
DAUGHTERBOARD MODULE
•
Place the keyset face down on a flat surface.
•
Remove the base pedestal by placing your thumbs over the attachment
clips and press outward while simultaneously pressing down on the key-
set body with your fingertips.
•
Remove the two knockouts from the bottom of the keyset.
•
Plug in the daughter module and secure with the two screws provided.
SECURING
SCREWS
REMOVE
KNOCKOUTS
OUTSIDE CALLS
MAKING AN OUTSIDE CALL
•
Lift the handset and press an idle outside line button, line group button
or dial a line access code to receive dial tone—OR—press an idle out-
side line button, line group button or dial a line access code to receive
dial tone through the speaker—OR—press SPEAKER, receive intercom
dial tone and dial a line access code.
•
Dial the telephone number.
•
Finish the call by replacing the handset or pressing the ANS/RLS key.
NOTE: You will receive No More Calls tone when you attempt to make a call
and there is no key available for that line.
•
If Least Cost Routing is enabled on your phone system, this button may
be labeled LCR or accessed by dialing an access code (usually 9).
•
If your system is programmed to require an authorization code before
making a call, dial
•
If your system is programmed to require an account code before mak-
ing a call, press the ACCT button or dial 47 plus a valid bin number,
press the ACCT button again and then select a C.O. line.
For more information on authorization and account codes, see your system
administrator.
NOTE: If the Hot Keypad feature has been turned off, you must first lift the
handset or press the SPEAKER key before dialing.
ANSWERING AN OUTSIDE CALL
•
Lift the handset and you are automatically connected to the ringing call.
See Ring Preference under Customizing Your Keyset—OR—press the
ANS/RLS key to automatically answer on the speakerphone.
NOTE: If a call is flashing at your keyset but not ringing, you must press the
flashing button to answer.
UNIVERSAL ANSWER
Outside lines may be programmed to ring a general alerting device. To
answer calls ringing this device, dial 67 or press the UA key. This device can
operate in any one of the six different ring plans.
NOTE: If the Hot Keypad feature has been turned off, you must first lift the
handset or press the SPEAKER key before dialing.
13
14
plus a valid code before selecting a C.O. line.
Advertisement
Table of Contents
