A-4
5. Connect the input control cable polarized
Amphenol plug into the mating 6-pin receptacle
on the rear of the control section.
6. Referring to Figure A.2, install the input cable
under the wire reel mounting stand strain relief
INSTALLATION
FIGURE A.2 – STRAIN RELIEF CLAMP.
ELECTRODE
LN-7 & LN-7 GMA
clamp. Remove the screws holding the clamp to
the base of the wire reel mounting assembly, put
the input cable assembly under the clamp and
reinstall the screws.
CONTROL
CABLE
STRAIN
RELIEF
CLAMP
CABLE
A-4