Front I/O Assembly - HP ProDesk 400 G1 Maintenance And Service Manual

Front I/O assembly

Description
Front I/O assembly
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Rotate the drive cage to its upright position.
5.
Cut the plastic tie that secures the longer cable to the power supply.
6.
Disconnect the cables from the system board as follows:
Yellow connector labeled FRONT USB
●
Blue connector labeled FRONT USB 3.0
●
Blue connector labeled FRONT AUD
●
122 Chapter 6 Removal and replacement procedures: Small Form Factor
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 94).
93).
Spare part number
745037-001
92).