Table of Contents
Advertisement
A-3
LIFTING
The Commander lift bale should be used to lift the
machine. The Commander is shipped with the lift bale
retracted. Before attempting to lift the Commander the
lift bale must be secured in a raised position. Secure
the lift bale as follows:
a. Open the engine compartment door.
b. Locate the 2 access holes on the upper middle
region of compartment wall just below the lift
bale.
c. Use the lifting strap to raise the lift bale to the full
upright position.
This will align the mounting
holes on the lift bale with the access holes.
d. Secure the lift bale with 2 thread forming screws.
The screws are provided in the shipped loose
parts bag.
WARNING
FALLING EQUIPMENT can cause
injury.
•Do not lift this machine using lift bale if
it is equipped with a heavy accessory
such as a trailer or gas cylinder.
•Lift only with equipment of adequate
lifting capacity.
•Be sure machine is stable when lifting.
------------------------------------------------------------------------
HIGH ALTITUDE OPERATION
At higher altitudes, output derating may be necessary.
For maximum rating, derate the welder output 5% for
every 300 meters (984 ft.) above 1500 meters (4920
ft.). For output of 500A and below, derate the welder
output 5% for every 300 meters (984 ft.) above 2100
meters (6888 ft.).
Contact a Deutz Service Representative for any
engine adjustments that may be required.
HIGH TEMPERATURE OPERATION
At temperatures above 30°C (86°F), output voltage
derating is necessary. For maximum output current rat-
ings, derate welder voltage rating 2 volts for every
10°C (21°F) above 30°C (86°F).
INSTALLATION
TOWING
The recommended trailer for use with this equipment
for road, in-plant and yard towing by a vehicle (1) is
Lincoln's K953-1. If the user adapts a non-Lincoln trail-
er, he must assume responsibility that the method of
attachment and usage does not result in a safety haz-
ard nor damage the welding equipment. Some of the
factors to be considered are as follows:
1. Design capacity of trailer vs. weight of Lincoln
equipment and likely additional attachments.
2. Proper support of, and attachment to, the base of
the welding equipment so that there will be no
undue stress to the trailer's framework.
3. Proper placement of the equipment on the trailer to
insure stability side to side and front to back when
being moved and when standing by itself.
4. Typical conditions of use, such as travel speed,
roughness of surface on which the trailer will be
operated, and environmental conditions.
5. Proper preventative maintenance of trailer.
6. Conformance with federal, state and local laws.
1
Consult applicable federal, state and local laws
regarding specific requirements for use on public high-
ways.
COMMANDER 500
A-3
1
Advertisement
Table of Contents
Troubleshooting
