Electrical Information; Wiring Diagram - Napoleon XIR4-1N Installation And Operating Instructions Manual

16

5.0 ELECTRICAL INFORMATION

EN
DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER. CALL A QUALIFIED
SERVICE TECHNICIAN IMMEDIATELY TO HAVE THE APPLIANCE INSPECTED FOR DAMAGE TO THE
RISK OF ELECTRICAL SHOCK OR EXPLOSION. DO NOT WIRE 110V TO THE VALVE OR TO THE
ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCE
WITH LOCAL CODES. IN THE ABSENCE OF LOCAL CODES, USE THE CURRENT CSA22.1 CANADIAN
ELECTRIC CODE IN CANADA OR THE CURRENT NATIONAL ELECTRIC CODE ANSI/NFPA NO. 70 IN
ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RAN OUT,
5.1

WIRING DIAGRAM

This appliance comes equipped with a battery back-up. If this back-up is used, install 4 AA batteries (not
supplied) into the receiver.
Wire
Harness
Plug
W415-1194 / 03.04.13
APPLIANCE WALL SWITCH. INCORRECT WIRING WILL DAMAGE CONTROLS.
WITH THE GLASS DOOR OPENED OR REMOVED.
ACS/IPI Switch
(OPTIONAL)
Fan
Night Lights
(OPTIONAL)
120V OUT
FAN
AUX OUT
POWER
COM
Control Module
Receiver
Wire Harness
WARNING
!
ELECTRICAL CIRCUIT.
THE UNITED STATES.
Valve
Electronic Modulation
Wire Harness Assembly
69.2
Spark Electrode
Flame
Sensor
EI
Pilot
Pilot
Ground
Wire
IPI Board