1.6 Selecting the operation mode
(Scan/Copy/Fax/Print)
You can select the desired mode by pressing one of the
following buttons.
– {Scan}: Select this mode when using the unit as a
scanner.
– {Copy}: Select this mode when using the unit as a
copier.
– {Fax}: Select this mode when using the unit as a fax
machine.
– {Print}: Select this mode when using the unit as a
printer.
Document Requirements
1.7 Setting the original
1.7.1 Using the scanner glass
1
Open the document cover (1).
2
Place the document FACE DOWN on the scanner
glass (2), aligning the top left of the document with
the corner to which the m mark points.
3
Close the document cover.
1
2
Detailed operating instructions are on the CD-ROM.
1. Introduction and Installation
1.7.2 Using the automatic document feeder
1
1
Insert the document (up to 50 pages) FACE UP into
the feeder until a single beep is heard.
2
Adjust the width of the document guides (1) to fit
the actual size of the document.
Volume
1.8 Adjusting the volume
Important:
L Before adjusting the volume, set the operation
mode to fax mode. If the {Fax} light is OFF, turn it
ON by pressing {Fax}.
Ringer volume
1. Press {V} or {^} repeatedly to select "Ringer
Volume".
2. Press {<} or {>}.
To turn the ringer OFF
1. Press {V} or {^} repeatedly to select "Ringer
Volume".
2. Press {<} repeatedly to display "Ringer Off" in
the status bar.
L The unit will not ring.
L To turn the ringer back ON, press {>}.
Monitor volume
1. While using the monitor, press {V} or {^}
repeatedly to select "Monitor Volume".
2. Press {<} or {>}.
Initial Programming
1.9 Date and time
1
{Menu} i {#}{1}{0}{1} i {Set}
2
Enter the current month/date/year/hour/minute.
11