Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for E-FLITE Rhapsody 25e ARF
Summary of Contents for E-FLITE Rhapsody 25e ARF
- Page 1 Rhapsody 25e ARF Assembly Manual...
-
Page 2: Table Of Contents
Preflight ............... 19 Weight with Battery: 4.40–4.60 oz (1.90–2.10 kg) to become familiar with the features of the product Flying Your Rhapsody 25e ARF ......20 Weight w/o Battery: 3.70–3.90 oz (1.60–1.80 kg) before operating. Failure to operate the product correctly can result in damage to the product, personal Range Test Your Radio .......... -
Page 3: Contents Of Kit/Parts Layout
Top/bottom wing retention bolt 4-40 x 1/2-inch socket head bolt The Spektrum trademark is used with permission of Bachmann Industries, Inc. All other marks are trademarks or registered trademarks of Horizon Hobby, Inc. E-flite Rhapsody 25e ARF Assembly Manual... -
Page 4: Warnings
Ni-Cd/ Ni-MH batteries used in RC applications. Always follow the manufacturer’s instructions when using and disposing of any batteries. Mishandling of Li-Po batteries can result in fire and explosion causing serious injury and damage. E-flite Rhapsody 25e ARF Assembly Manual... -
Page 5: Landing Gear Installation
7/64-inch hex wrench or ball driver. Please make sure the landing gear angles forward. Important: Do not over-tighten the nuts as this could damage the stabilizer. E-flite Rhapsody 25e ARF Assembly Manual... - Page 6 6. Repeat Steps 2 through 5 to install the remaining collars. Position the flats 1/4-inch (6mm) and 1 wheel to the landing gear. inch (28mm) from the outer end of the axle as shown. E-flite Rhapsody 25e ARF Assembly Manual...
-
Page 7: Motor, Speed Control And Cowling Installation
The front is installations. You will need to adjust their position held in place using two dowels. to suit your particular motor selection. E-flite Rhapsody 25e ARF Assembly Manual... - Page 8 E-flite components. Use 6-minute epoxy to glue the dummy radial engine inside the cowling. Use the following colors to paint the dummy radial engine.
-
Page 9: Aileron Servo Installation
This hole is 3/8-inch (10mm) from the center of the horn as shown. Use side cutters to remove any unused arms so they don’t interfere with the operation of the servo. E-flite Rhapsody 25e ARF Assembly Manual... - Page 10 Tie the string to the end of servo lead. the servo lead as shown. Attach clevis to outer hole Drawing not to scale 11. Repeat Steps 1 though 10 to install the remaining aileron servo. E-flite Rhapsody 25e ARF Assembly Manual...
-
Page 11: Rudder And Elevator Servo Installation
Use a #1 Phillips screwdriver to tighten the wire to the servo horn using the bend in the wire. screws. Note that the output for the servos face to the front of the fuselage. E-flite Rhapsody 25e ARF Assembly Manual... - Page 12 Attach clevis to outer hole to outer hole Drawing not to scale Drawing not to scale When centering the control surfaces, use a ruler or straightedge to make sure the surface is in alignment. E-flite Rhapsody 25e ARF Assembly Manual...
-
Page 13: Bottom Wing And Receiver Installation
5. Attach the center section to the fuselage using two 6-32 x 1-inch socket head machine screws and two #6 washers. Use a 7/64-inch hex wrench to tighten the screws. E-flite Rhapsody 25e ARF Assembly Manual... -
Page 14: Top Wing Installation
We left the string tied to the aileron servo lead, but cut it to a length of 3-inches (76mm) so the lead can be easily retrieved if it falls back into the wing. E-flite Rhapsody 25e ARF Assembly Manual... - Page 15 3. Attach the top wing center section to the cabane struts using four 4-40 x 3/8-inch socket head machine screws and four #4 washers. Use a 3/32- inch hex wrench to tighten the screws. E-flite Rhapsody 25e ARF Assembly Manual...
- Page 16 Once the length is set, make sure both clevises are ball driver to tighten the screws for this step. secure and that the silicone retainer has been slid over the forks of the clevis. Repeat for the opposite aileron connection. E-flite Rhapsody 25e ARF Assembly Manual...
-
Page 17: Removing The Wing Panels
3. Repeat Steps 1 and 2 to remove the remaining wing panels from the fuselage. Note: To reattach the wings, simply step through Steps 1 through 3 in reverse order. E-flite Rhapsody 25e ARF Assembly Manual... -
Page 18: Center Of Gravity
Squeegee the excess water from under the decal and allow them to set overnight before flying your model. E-flite Rhapsody 25e ARF Assembly Manual... -
Page 19: Control Throws
Elevator Low Rate 1/2-inch (13mm) Down 1/2-inch (13mm) Aileron High Rate (100%) 5/8-inch (15mm) Down 5/8-inch (15mm) Aileron Low Rate 3/8-inch (9mm) Down 3/8-inch (9mm) E-flite Rhapsody 25e ARF Assembly Manual... -
Page 20: Flying Your Rhapsody 25E Arf
• D o not take chances. If at any time during flight you observe any erratic or abnormal operation, land immediately and do not resume flight until the cause of the problem has been ascertained and corrected. Safety can never be taken lightly. • Do not fly near power lines. E-flite Rhapsody 25e ARF Assembly Manual... -
Page 21: Warranty And Repair Policy
Notice: Do not ship batteries to Horizon. If than Horizon. Return of any Product by Purchaser must you have any issue with a battery, please be approved in writing by Horizon before shipment. contact the appropriate Horizon Product Support office. E-flite Rhapsody 25e ARF Assembly Manual... -
Page 22: Compliance Information For The European Union
I operate model aircraft with fuels you purchased the product. containing tetranitromethane or hydrazine. Age Recommendation: 14 years or over. Not a toy. Not intended for use by children without direct adult supervision. E-flite Rhapsody 25e ARF Assembly Manual... - Page 23 I will have completed a successful radio equipment Model Aircraft Safety Code. ground-range check before the first flight of a new or repaired model aircraft. E-flite Rhapsody 25e ARF Assembly Manual...
- Page 24 © 2010 Horizon Hobby, Inc. horizonhobby.com www.e-fliterc.com 17632 Created 05/2010...