Camshaft Assembly For The Fuel Injection Pump - To Remove And To Fit - Perkins 700 Series User Handbook Manual

Section 15
Timing Case and Drive Assembly
Operation:

Camshaft assembly for the fuel injection pump - to remove and to fit

Recommended torque:
Engine type Nm
-
-
-
Release the setscrew for the plate that retains
the camshaft bearing.
Rotate the plate 180° and tighten the setscrew.
This will hold the plate away from the bearing.
05/99
Printed in England
© Propriety information of Perkins Engines Company Limited, all rights reserved
Special notes and tools:
lbf ft kgf m Note: The camshaft is supplied only as an assembly of camshaft, bearing and
gear. If the bearings, the cams or the gear is worn, a new camshaft assembly
will have to be fitted. If this occurs, the fuel injection timing will have to be set,
see operation 17.04.
700 Series
15.09
Maximum permissible
end float
0,35 mm
(0.014 in)
86