Construction; Function Configuration; Basic Sequence; Basic Operation Sequence - Canon i-SENSYS MF4300dn Service Manual

2.1 Construction

2.1.1 Function Configuration

i-SENSYS MF4300dn / i-SENSYS MF4350d / i-SENSYS MF4380dn / i-SENSYS MF4310/4318 / i-SENSYS MF4320d / i-SENSYS MF4330d / i-SENSYS
MF4340d / i-SENSYS D450d / i-SENSYS MF4370dn
The functions of this host machine are mainly composed of the 7 blocks: System
Control System, Scanning Control System, Printer Control System, Laser Scanner System, Image Formation System, Fixing System, Pickup/Feeding System.
Below is the block diagram.

2.2 Basic Sequence

2.2.1 Basic Operation Sequence

i-SENSYS MF4300dn / i-SENSYS MF4350d / i-SENSYS MF4380dn / i-SENSYS MF4310/4318 / i-SENSYS MF4320d / i-SENSYS MF4330d / i-SENSYS
MF4340d / i-SENSYS D450d / i-SENSYS MF4370dn
The operations of this host machine are controlled by CPUs of the SCNT PCB within the Reader Controller System and the DCNT PCB within the Engine Control
System. The table below shows the purpose of each interval and the outline of the operations of reader unit and the engine from turnon of the power supply to stop
of each motor after printing.
interval name definition of interval
WAIT (wait) Interval between turnon of the
power supply and the end of the
initial drive
STBY (standby) Interval between the end of WAIT
or LSTR and input of print
command from SCNT PCB, or
interval between the end of LSTR
and turnoff of power supply
INTR (initial rotation) Interval between the input of print
command from SCNT PCB and
turnon of the Cassette pickup
solenoid
PRINT (print) Interval between the end of initial
rotation and turnoff of the primary
high-voltage output
LSTR (last rotation) Interval between turnoff of the
primary high-voltage output and
stop of the main motor
System Control
System
Printer Control
System
purpose
To clear the drum surface potential
and to execute the cleaning of
transfer charging roller
To make the host machine ready for
printing
To stabilize the photosensitive drum
as a preparation for printing
Also to clean the transfer charging
roller
To form an image onto the
photosensitive drum based on the
video signal input from the SCNT
PCB and to transfer the toner image
onto media
To fully deliver the final sheet
printed
Also to clean the transfer charging
roller
Scanning Control System
Laser / Scanner System
Image Formation System
Fixing System
Pickup / Feeding System
F-2-1
T-2-1
remarks
Presence/absence of cartridge is detected during this interval.
On input of print command from the SCNT PCB, host machine
enters INTR immediately after LSTR. However, depending on the
conditions shown below, the host machine may not start INTR
immediately.
-media size
-temperature of the fixing assembly
Chapter 2
0020-2566
0020-2567
2-1