Introduction - Baxi 100 He Installation And Servicing Instructions

Position of Label
Fig. 1
Lower Door Panel
Air Box Door
Fig. 2
"Benchmark" Log Book
As part of the industry-wide "Benchmark" initiative all Baxi boilers now
include an Installation, Commissioning and Service Record Log Book.
Please read the Log Book carefully and complete all sections relevant to
the appliance and installation. These include sections on the type of
controls employed, flushing the system, burner operating pressure etc.
The details of the Log Book will be required in the event of any warranty
work. Also, there is a section to be completed at each subsequent regular
sevice visit.
4
H IG
H
LO
W
H IG
H
LO
W
Data Badge

1.0 Introduction

Baxi UK Limited declare that no substances
harmful to health are contained in the appliance
or used during appliance manufacture.
NOTE: This appliance must be installed in
accordance with the manufacturer's instructions
and the regulations in force, and only used in a
suitably ventilated location.
All systems must be thoroughly flushed and
treated with inhibitor (see Section 6.2).
Read the instructions fully before installing or
using the appliance.
1.1 Description
1. The Baxi 100 HE is a gas fired room sealed fan
assisted condensing central heating boiler.
2. The maximum output of the boiler is preset at
75,000 Btu/hr. The boiler will automatically adjust
down to 30,000 Btu/hr according to the system
load. If required, the output can be set to 100,000
Btu/hr. Please refer to section 8.8.
3. It is designed for use on Natural Gas (G20).
4. The boiler is suitable for fully pumped open
vented central heating and domestic hot water
systems and sealed systems.
5. A label giving details of the model, serial number
and Gas Council number is situated on the rear of
the lower door panel (Fig. 1).
6. The boiler data badge is positioned on the air
box door (Fig. 2).
7. The boiler is intended to be installed in
residential / commercial / light industrial E.M.C.
environments on a governed meter supply only.
8. The boiler must be installed with one of the
purpose designed flues such as the standard
horizontal flue kit, part n o 236921.
1.2 Important Information
This product contains Refractory Ceramic Fibres
(R.C.F.) which are man-made vitreous silicate fibres.
Excessive exposure to these materials may cause
temporary irritation to eyes, skin and respiratory tract.
Care must be taken when handling these articles to
ensure the release of dust or fibres is kept to a
minimum.
To ensure that the release of fibres from these articles
is kept to a minimum, during installation and servicing
it is recommended that a H.E.P.A. filtered vacuum is
used to remove any dust, soot or other debris
accumulated in and around the appliance. This should
be performed before and after working on the
installation.
It is recommended that any replaced item(s) are not
broken up but sealed within heavy duty polythene
bags and clearly labelled "R.C.F. waste". This is not
classified as "hazardous waste" and may be disposed
of at a tipping site licensed for the disposal of
industrial waste.
Protective clothing is not required when handling
these articles but it is recommended that gloves are
worn and the normal hygiene rules of not smoking,
eating or drinking in the work area are followed and
always wash hands before eating or drinking.