Adjusting The Squelch; Setting The Backlight - Uniden UBC126AT Owner's Manual

Adjusting the Squelch

Press Func, then press SCROll CONTROl. The squelch
1.
level indicator from 0 to 15 and battery voltage appears.
Turn SCROll CONTROl until the audio mutes. If the
2.
scanner picks up unwanted partial signals or very weak
transmissions, increase the Squelch setting to increase the
signal level required to open squelch. To listen to a weak or
distant station, decrease the Squelch setting.
Press SCROll CONTROl to set the desired level and return
3.
to the previous mode.

Setting the Backlight

Press to turn on the backlight on and off.
Press Func and
1.
From this menu, scroll to Set Backlight from the
2.
submenus. Press SCROll CONTROl.
3. Scroll to select one of the following settings:
• Always Off - Backlight is always off.
• Always On – Backlight is always on.
• On with Squelch - Backlight is on while squelch is open
and until delay expires.
• On with Keypress - Backlight is on for 10 seconds after
any key is pressed.
• Keypress+Squelch – Both above-mentioned "Squelch"
and "Keypress."
• < Back - Return to previous menu.
30
to view the Display/Charge menu.