Heat & Glo SL-550TR-E Owner's Manual page 62

3 3
Figure 6 Figure 6
Log #3: Locate the pin hole on the underside of log #3.
Mate the pin hole with the shoulder screw located on the
burner top. Push the left end of log # 3 toward the back of
the fi rebox until it touches the lava rock retainer.
Swing knot towards log #3 Swing knot towards log #3
Figure 8 Figure 8
Log #4: Locate the notch at the end of log # 4. Mate the
notch with the tine as shown above. The top end of log #4
should rest between the end of log #2, and the bump located
on log #1. Swing the knot on log # 4 towards log #3.
Figure 10 Figure 10
Step #6: Apply the supplied lava rock as shown above. Place
an even layer of lava rock in zone shown in Figure 1. The
amount should be just enough to cover the metal surface.
Take care to ensure that no lava rock is placed outside the
zone indicated in Figure 1.
62
Pin hole Pin hole
Bump Bump
4 4
Mate notch with grate tine Mate notch with grate tine
Lava Rock Lava Rock
Heat & Glo • SL-550 / 750 / 950TR-E • 2118-900 Rev. AC • 3/15
Log should touch lava rock retainer Log should touch lava rock retainer
3 3
Mate shoulder screw with pin hole Mate shoulder screw with pin hole
Figure 7 Figure 7
Figure 9 Figure 9
Log #5: Locate the notch at the end of log # 5. Mate the
notch with the far right grate tine. The top end of log # 5
should rest on the right side of the "bump" as shown above.
You may need to move log #4 slightly.
WARNING
RISK OF EXPLOSION!
• Place lava rock according to instructions.
• Do NOT place lava rock on burner top.
• Do NOT place lava rock in a position that they may
fall into pilot area.
• Improperly placed lava rock interferes with proper
burner operation.
Delayed ignition could occur.
• Use ONLY Hearth & Home Technologies-approved
lava rock.
• Some models may not require use of entire contents
of bag.
Bump Bump
5 5
Mate notch with grate tine Mate notch with grate tine