Notis Editing; Set Lengths For Codabar; One Discrete Length (Parameter L1) - Honeywell 8650 User Manual

NOTIS Editing

When enabled, the start and stop characters are stripped from a decoded Codabar symbol.
Set this parameter by scanning either of the bar codes shown below.
Enable NOTIS Editing
* Disable NOTIS Editing

Set Lengths for Codabar

L1 Default: 5
L2 Default: 55
Lengths for Codabar may be set for:
any length,
one or two discrete lengths,
or lengths within a specific range.
The length of a code refers to the number of characters, including check digits, the code contains. It also includes any start
or stop characters.
See the table titled ASCII Character Equivalents

One Discrete Length (Parameter L1)

This option decodes only those codes containing a selected length. For example, when you want to scan only Cod-
abar symbols containing 14 characters, scan the Codabar One Discrete Length bar code and then "1" and "4" bar
codes using the Imager Keypad Number Symbols
To begin setting one discrete length, scan this Codabar One Discrete Length bar code:
Next, scan two numeric bar codes that correspond to the desired value. Single digit numbers must have a leading
zero. To correct an error or to change a selection, scan Cancel on the Imager Keypad Number Symbols page.
(page 9-2).
(page 5-81).
5 - 57