Unpacking And Levelling; Electric And Water Connections; Installation - Indesit WITXL 109 Instructions For Use Manual

Installation


Keep this instruction manual in a safe place for future
GB
reference. Should the appliance be sold, transferred or
moved, make sure the instruction manual accompanies
the washing machine to inform the new owner as to its
operation and features.

Read these instructions carefully: they contain vital
information on installation, use and safety.

Unpacking and levelling

Unpacking
5. Keep all the parts: you will need them again if the
washing machine needs to be moved to another location.
Warning: should the screws be re-used, make sure you
fasten the shorter ones at the top.

Packaging materials are not children's toys.
Levelling
Your machine may make a considerable amount of noise if
the two front feet have not been adjusted correctly.
inclination, measured according to the worktop, must not
exceed 2°.
Levelling your appliance correctly will provide it with
stability and avoid any vibrations, noise and shifting during
2
1. Unpack the washing
machine.
2. Check whether the
washing machine has
been damaged during
transport. If this is the
case, do not install it and
contact your retailer.
3. Remove the four
protective screws and the
rubber washer with the
respective spacer, situated
on the rear of the
appliance (see figure).
4. Seal the gaps using the
plastic plugs provided.
1. Install the washing
machine on a flat sturdy
floor, without resting it up
against walls, furniture
cabinets or other.
2. If the floor is not perfectly
level, compensate for any
unevenness by tightening or
loosening the adjustable front
feet (see figure); the angle of
operation. If it is placed on a fitted or loose carpet,
adjust the feet in such a way as to allow enough
room for ventilation beneath the washing machine.
Putting your appliance in place and moving it.
base. Once the appliance is in the required position,
put the lever back in place. The washing machine is
now firmly in place (see figure).

Electric and water connections

Connecting the water inlet hose
A
3. Make sure there are no kinks or bends in the
hose.

The water pressure at the tap must be within the
values indicated in the Technical details table
(on the next page).

If the water inlet hose is not long enough, contact
a specialist store or an authorised serviceman.

Never use hoses that have already been used.
If your washing
machine is equipped
with a special set of
retractable wheels you
can easy move it. To
lower the wheels and
thus move the
appliance effortlessly,
just pull the lever,
situated on the left-
hand side beneath the
1. Insert seal A into the
end of the inlet hose
and screw the latter
onto a cold water tap
with a 3/4 gas
threaded mouth (see
figure).
Before making the
connection, allow the
water to run freely until
it is perfectly clear.
2. Connect the other end
of the water inlet hose to
the washing machine,
screwing it onto the
appliance's cold water
inlet, situated on the top
right-hand side on the
rear of the appliance
(see figure).