Channel Programming; How To Program User Channel - Furuno FS-1503 Service Manual

4.3 Channel Programming

199 user channels are divided into two bands; 0 and 1. Further channels are divided into
ten scan groups which are able to be scanned as a group.
TX and RX frequencies and class of emission can be preset on each user channel.
In addition, a user channel name can be entered on 65 channels, 0-01 to 0-065.
Band Channel
0 1 to 99

How to program user channel

1. While pressing and holding down [CH], turn the power on.
2. Select system channel 9999 by rotating the FREQ/CH knob.
3. Enter a password. (Press [CH], type password, and then press [ENT].)
4. Select channel 9998 by rotating the FREQ/CH knob.
5. Press [CH], [1], and [ENT] in this order to enable channel programming.
If [CH], [0], and [ENT] are pressed, not only channel programming but also power
adjustment can be made.
6. Select an RX channel to be programmed by rotating the FREQ/CH knob. The display
changes as follows when the knob is rotated: RX frequency, TX frequency, and chan-
nel name can be preset on a channel in this order. Note that the channel name cannot
be entered on channel 66 and above.
[0-01⋅R] → [0-01⋅T] → [0-01⋅-----] → [0-02⋅R] → [0-02⋅T] → [0-02⋅-----] →
⋅⋅⋅⋅⋅⋅⋅⋅⋅⋅⋅⋅⋅⋅⋅⋅⋅⋅⋅⋅[1-00⋅R] → [1-00⋅T] → [1-01⋅R] → ----------
7. Select the emission mode by pressing [MODE]: J3E for SSB radiotelephone and TLX
for DSC and NBDP.
Scan
Remarks
Group
01 to 09
10 to 19
20 to 29
30 to 39
40 to 49
50 to 59
60 to 69
70 to 79
80 to 89
90 to 99
4-8
Scan
Band Channel
Group
00 to 09
10 to 19
20 to 29
30 to 39
40 to 49
1 0 to 99
50 to 59
60 to 69
70 to 79
80 to 89
90 to 99
Remarks