Assembly - Ariens Sno-Thro 920001- ST624E Owner's/Operator's Manual

WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
WARNING: Dropping or tipping over boxed
unit could result in personal injury or damage
to unit.
PACKAGE CONTENTS
2
4
1
1. Sno-Thro Unit
2. Discharge Chute
3. Chute Rod Figure 3

ASSEMBLY

Tools Required:
• Pliers
• Open-End Wrenches: 3/8, 7/16, 1/2,
9/16 in. and/or Adjustable Wrench
• Tire Gauge
Unfold Handlebar (Figure 4)
1. Remove the lower and loosen the upper wing
knobs on the handlebar assembly.
2. Loosen the wing nuts on the shift rod.
3. Put the speed selector lever in the sixth forward
position.
4. Rotate the handlebars into operating position.
5. Install and tighten all wing knobs and wing nuts
on the handlebar assembly and shift rod.
ASSEMBLY
3
OS8020
4. Literature Pack with
Extra Shear Bolts
.
2
3
1. Shift Rod
2. Wing Knob
and Bolt
3. Wing Nut and
Bolt
4. Handlebar
Install Discharge Chute (Figure 5)
1. Grease underside of discharge chute ring (if not
already greased).
2. Remove mounting hardware from the bottom of
the chute pedestal.
3. Install discharge chute over opening in the auger
housing and secure pedestal to auger housing
with hardware removed in step 2.
2
3
1
1. Mounting Hardware
2. Discharge Chute
3. Discharge Chute Ring
4. Chute Pedestal
Install Discharge Chute Crank
1. Slide Chute Crank through the nylon bushing in
the support bracket.
GB - 7
1
4
OS8025
Figure 4
1
4
OS8030
Figure 5