Maintenance - Ariens Sno-Thro 920001- ST624E Owner's/Operator's Manual

To clear an area, run unit in an overlapping series of
paths. For large areas, start in the middle and throw
snow to each side, so snow is not cleared more than
once.
ALWAYS direct snow away from area to be cleared and
with direction of the wind.
TRAVELING
To travel from one work area to another:
1. Set Throttle to Slow or Part-Throttle position.
2. Press down on handlebars enough to raise front
of unit slightly off surface.
Ariens Dealers will provide any service or adjustments
which may be required to keep your unit operating at
peak efficiency. Should engine service be required,
contact an Ariens dealer or an authorized engine
manufacturer's service center.
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
SERVICE POSITION
WARNING: Before tipping unit up onto
housing, remove fuel so no spills will occur.
Ensure unit is secure and will not tip over
during maintenance.
Place unit on a flat level surface. Tip unit forward onto
front of auger housing for service. Ensure unit is secure
and will not tip over. Strap and clamp onto bench if
needed.
Service Position
Figure 11
3. Engage wheel drive clutch without engaging
attachment drive clutch.
TRANSPORT
ALWAYS shut off engine, remove key, and close fuel
shut-off valve when transporting unit on a truck or
trailer.
Use extra care when loading or unloading unit onto
trailer or truck.
Secure unit chassis to transport vehicle. NEVER
secure from rods or linkages that could be damaged.
DO NOT transport machine while engine is running.

MAINTENANCE

MAINTENANCE SCHEDULE
The chart below shows the recommended
maintenance schedule that should be performed on a
regular basis. More frequent service may be required.
Service Performed
Check Dual Handle
Interlock
Check Fasteners
Check Clutch
Operation
Check Clutch Spring
Adjustments
Clean Engine
Check Engine Oil
Change Engine Oil
Check Tire Pressure
Check Auger
Gearcase
General Lubrication
*
After first five hours of operation.
**
After first two hours of operation.
CHECK DUAL HANDLE INTERLOCK
Without the engine running, press down (engage) both
clutch levers. Release attachment clutch lever.
Attachment clutch should remain engaged until traction
clutch lever is released, then both clutches must
disengage.
CHECK FASTENERS
Make sure all hardware is tightened properly.
CHECK CLUTCH OPERATION
Auger / impeller must stop within 5 seconds when
attachment clutch/impeller brake lever is released.
OS8045
GB - 14
MAINTENANCE SCHEDULE
Each Use Every 5
hrs.
•
•
•
*
•
•
**
Every 25 Yearly
hrs.
•
•
•
• •
• •