Assembly Step - Horizon Fitness Andes 208 Assembly Manual

ASSEMBLY STEP 1

HARDWARE BAG FOR STEP 1 CONTENTS :
ASSEMBLY STEP 2
HARDWARE BAG FOR STEP 2 CONTENTS :
15
A) Open HARDWARE BAG FOR
STEP 1.
B) Attach STABILIZER TUBE to the
MAIN FRAME using 2 BOLTS (A).
A) Open HARDWARE BAG FOR
STEP 2.
B) Slide left and right GUIDE
RAILSintoMAIN FRAME.
C) Attach GUIDE RAILS using 2
BOLTS (B).
NOTE: You may have to rotate the
guide rails back and forth to get them
to slide into the frame.
3
ASSEMBLY STEP 3
CONSOLE MAST
CONSOLE MAST BOOT
ARC WASHERS (E)
BOLTS (C)
NUT (F)
LOCK WASHERS (D)
BOLT (B)
MAIN FRAME
A) Open HARDWARE BAG FOR STEP 3.
B) Slide the CONSOLE MAST BOOT over the bottom of the CONSOLE MAST.
C) Carefully pull console wires through the CONSOLE MAST. Attach the CONSOLE WIRES to the pre-
attached routing wire. Discard wire when finished.
D) Slide CONSOLE MAST into MAIN FRAME.
E) Insert 3 BOLTS (C), 3 LOCK WASHERS (D) and 3 ARC WASHERS (E) into back of CONSOLE MAST.
F) Attach CONSOLE MAST to MAIN FRAME using BOLT (B) and ARC WASHERS(E) usingNUT (F).
G) Slide CONSOLE MAST BOOT down to cover exposed bolts.
4
HARDWARE BAG FOR STEP 3 CONTENTS :
BOLT (C) SPRING
15 mm WASHER (D)
Qty: 3 Qty: 3
ARC NUT (F)
WASHER (E) M8
Qty: 4 Qty: 1
BOLT (B)
70 mm
Qty: 1