Life Fitness 95Te Operation Manual page 13

H P
OW TO OSITION AND
Following all safety instructions in Section 1.1, move the
treadmill to the location in which it will be used. See
Section 7, titled Specifications, for the dimensions of the
product footprint (assembled dimensions.) Allow a dis-
tance of eight inches, or 21 centimeters, between the
treadmill and other units on either side. Allow a distance
of six feet, or two meters, from the rear of the treadmill to
any object or surface.
After placing the unit where it will be used, check its stability. If there is even a slight rocking
motion or the unit is not stable, determine which stabilizing leg is not resting on the floor. To
adjust, loosen the JAM NUT (A), and turn the STABILIZING LEG (B) until the rocking motion
ceases, and both stabilizing legs rest firmly on the floor. Retighten the JAM NUT.
NOTE: It is extremely important that the stabilizing leg be correctly adjusted for proper opera-
tion. An unbalanced unit may cause striding belt misalignment. A bubble level is recommended
to ensure proper leveling.
P S
OWER WITCH
Located on the front panel at the base of the treadmill, the ON/OFF switch has two positions:
"I" (one) for ON and "0" (zero) for OFF.
S C
ETTING THE
The unit contains a clock, which is used for system maintenance and event tracking. After the
unit has been turned ON, the display will prompt the user to set the clock. This prompt appears
for the first three times that the unit is turned on.
To change the Clock setting, press and hold the COOLDOWN key. Then touch the Life Fitness
icon in the upper right hand corner of the screen twice consecutively (double-touch). From there
select Configuration, and then Clock. Use the up and down arrows to set the time, and then
select the AM or PM button. To set the date, use the Previous Month and Next Month buttons to
bring up the correct month and year on the calendar. Touch the appropriate day on the calendar.
Select OK to accept. At this point, the clock has been reset, and the normal startup procedure
continues.
12
S
TABILIZE THE
LOCK
L F T
IFE ITNESS READMILL