Panasonic PT-52LCX65-K Operating Instructions Manual page 20

Installation (continued)
How to connect the PC IN Terminals
Connecting a PC to PC IN
COMPUTER
RGB OUT
Conversion adapter
(If necessary)
PC IN Terminal (D-SUB 15P) Pin Layouts
5 4 3 2 1
10 9 8 7
15 14 13 12 11
Connection port view
Notes:
• Some PC models cannot be connected to the set. A conversion adapter is required to use the RGB cable (D-SUB 15P) (Not
included) to connect a Macintosh computer to the set. There is no need to use an adapter for computers with PC / AT compatible
D-SUB 15P terminal.
• The computer shown in the illustration is for example purposes only. Additional equipment and cables shown are not supplied
with this set.
• The picture will become dark if a PC signal with a vertical scanning frequency of 62 Hz is input. To obtain the optimum picture
quality with the Projection Display, a vertical scanning frequency of 60 Hz is recommended.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified frequency
range.
• Select the desired PC input position by pressing the TV/VIDEO button. (P. 32)
• AUDIO IN is shared with VIDEO 3 input.
20
AUDIO OUT
Connect a cable which matches the audio
output terminal on the computer.
Audio cable
(M3 stereo mini pin-PIN cable)
RGB cable (D-SUB 15P) (Not included)
Pin No.
1 R
2 G
6
3 B
4 NC
5 NC
6 Ground for R
7 Ground for G
8 Ground for B
NC: Not connected
Signal name Pin No.
9 NC
10 Ground
11 NC
12 NC
13 HD/CSYNC
14 VD
15 NC
Signal name