Saeco PHEDRA Manual page 31

Instant product preheating takes place if:
- at least 3 minutes have passed since the mixing bowl
was last used;
- the quantity of water for the instant product is < 50
units.
1.7.3.
Capp. PreHeat
00
after which a preheating cycle is requested before dispensing
steam (by setting this value to zero the preheating cycle
is disabled). This cycle improves the operation of the
Cappuccinatore after a long period of inactivity.
1.7.3.1.
Warm-Up T-Out
00
Cappuccinatore is enabled.
1.7.3.2.
Extra Time
00
reduced quantity of milk is dispensed in this case.
1.8.
Steam Cleaning
Cleaning Time") the vending machine will not allow brewing
any beverages with steam (under the letter "S" in the product
list) unless a cleaning cycle is activated. The message "NO
Cappuccino" will be displayed (by setting the number of
hours to zero the cleaning message and the stop status will be
disabled). The cycle can be activated in the "Maintenance"
menu as well as during normal operation of the machine
through the user cycle.
ACTIVATION USING THE MENU:
Select the option 1.8 in the "Maintenance" menu.
ACTIVATION DURING NORMAL OPERATION:
The machine must comply with the following:
1.Vending machine in its "Ready" status.
2. No brewing in progress.
3.Option "Enable Steam Wash" in the "System Management"
menu enabled.
To activate the cycle simply press the buttons corresponding
to beverages 4 and 8 simultaneously.
CYCLE DESCRIPTION:
The cycle operation is independent from the activation mode
(no matter if started or not from the "Maintenance" menu)
and it consists of two phases: the "Wash Cycle" and "Rinse
Cycle".
1. During the first phase, a display message will request to
pour the mix of water and cleaning solution (about 400
gr of water and Saeco compound). Simultaneously press
the buttons corresponding to beverages 4 and 8 to start
the "Wash Cycle". This phase will last 75 seconds, then
CAPP. PREHEAT
It refers to the circuit of the
Cappuccinatore: it allows
setting the minutes of inactivity
WARM-UP T-OUT
I t d e t e r m i n e s t h e d e l a y
t i m e ( i n m i n u t e s ) a f t e r
which the preheating of the
EXTRA TIME
Extra time (in tenths of seconds)
for steam dispensing applied in
case the circuit is cold, since a
Steam Cleaning
In case the steam circuit remains
inactive for some hours (to be
set under the option "Steam
the machine will pass to the following one.
2. During the second phase, a display message will request
to insert only the water container (about 400 gr of
water). Simultaneously press the buttons corresponding
to beverages 4 and 8 to start the "Rinse Cycle". This
cycle will last 75 seconds. At the end of this procedure,
the cleaning cycle will be considered as completed and
the Cappuccinatore as cleaned, thus enabling brewing
beverages with milk.
1.8.1.
Steam Cleaning Time
after which a cleaning cycle of the circuit is requested.
1.8.2.
Enable Steam Wash
two beverage buttons 4 and 8.
This allows executing a cleaning cycle on the circuit of the
Cappuccinatore without the need to open the machine.
1.9.
Rinse cycle
Si
performed as follows: the first rinsing takes place 10 minutes
after the "machine ready" status; if necessary, other rinses
occur 7 hours after the last dispensing.
1.10.
Pre-grinding
Si
1.11.
Program messages
...
1.11.1.
Stand-by
** DA5P MY07 **
1.11.2.
Preselection
Bevande con orzo
preselection key is active.
1.11.3.
Brewing
Attendere
English
Steam Cleaning Time
It refers to the circuit of the
Cappucinatore: it allows
setting the interval (in hours)
Enable Steam Wash
I f s e t o n Y E S , i t a l l o w s
starting the cleaning cycle by
simultaneously pressing the
Rinsing Cycle
It allows enabling of the
automatic rinsing of the mixing
bowls. The automatic rinsing is
Pre-grinding
Enables instant pre-grinding of
the coffee dose.
Programmable texts
STAND-BY TEXT
It enables setting the message
appearing on the display when
the vending machine is in
standard operating mode.
PRESELECTION TEXT
It allows setting the message
appearing on the display when
the preselection mode of the
DISPENSING TEXT
It allows setting the message
appearing on the display
when the vending machine is
dispensing a product.
31