ParaBody 660 User Manual page 39

STEP 42
• Securely assemble the ball end of the AB CABLE (103) and one 3-1/2" PULLEY (42) to the FRONT UPRIGHT (25) using two 3/8 X 2-
3/4" BOLTS (85), two 3/8" FLANGE SPACERS (49), two 3/8" WASHERS (91), and two 3/8" LOCKNUTS (92). (NOTE: The AB
CABLE (103) should be routed underneath the retaining bolt as shown in DETAIL 42.)
29
103
FIGURE 42
SEE DETAIL 39
FLOATING
PULLEY
92
42
FIGURE 43
STEP 43
• Run the AB CABLE (103) through the
39
25
103
AB CABLE
91
49
3/8 X 2-3/4" 85
DETAIL 42
floating pulley assembly, then screw the
threaded end of AB CABLE (103) approxi-
mately 3/4" into the end of the PULLEY
BRACKET (29) and tighten jam nut
securely as shown in FIGURE 43.
IMPORTANT! Make sure the cables are
running in the grooves of all pulleys.