Power-On Settings Chart - Yaesu FT-8500/mh-39 Manual

Power-On Settings
Some transceiver default operational settings can be enabled/disabled, changed or reset using a power-on
procedure. This requires holding a particular key (or key combination) depressed while turning the transceiver
on, as outline in the table below. For detailed explanations on how these affect transceiver operation refer to
the page(s) listed in the far right column.
Power-On Settings and Functions
Press and hold the following
key(s) while turning the trans-
ceiver on.
Operational Effect or Setting Enabled
Ref. Page
15
16
52
Enables Cross-Band Repeat Mode (bi-directional repeat).
Enable keypad direct-access mode (primary key function).
Enable keypad direct-access mode (alternate key function).
l j j
~ - - - = - - - - - - - - - - T - - - - - - - - - - - - - - - - - - - - - - - - - - r - - - _ - - - :
!:I>
i~"
&>
30
53
29
54
21,71
Adjust Memory Bank Ratio for VHF and UHF.
Toggle Direct Key Entry (menu 33) capability on/off.
Enables Transceiver Cloning Mode.
~
&
~
--J
Activate Memory-Only mode .
. _~l_~_!!'J_------------l
RUllol UtJor·ProururnrntJd Function KuytJ (MH-39 Mlc Conlroller CPU)
7i5
& ,p)~ & &) I
Reset Transceiver CPU and all operational settings to factory-default.
L.
&J.
r~
r-;-_--+--
~ -
~
Enable Extended Receive (110-174 MHz & 410-500 MHz).
50