Yaesu FT-8500/mh-39 Manual page 15

heater vent or where it could interfere with driving.
Make sure to provide plenty of space at the rear so
that air can flow freely through the heatsink. Refer to
the diagrams showing installation.
Transceiver Installation
CJ
Decide the mounting location with sufficient clear-
ance tor the transceiver, plus space for ventilation
around the cooling
tan
and above and below the
set. Use the mounting bracket as a template to
locate tno mounting holes. Use a 4.8-mm (3/16")
bit to drill the holes. and secure the bracket with the
supplied screws. washers and nuts (see diagram).
o
Position the transceiver in the bracket so that the
holes in the side are aligned with those in the
bracket, and bolt the transceiver into place using
the' supplied short screws and flat washers. The
MH-39 hanger may be installed wherever conven-
ient.
I
~
i
e
I
c
~
I
J1
13