Introduction
This is the configuration manual for following camera models:
TVB-2403
TVB-4403
TVB-2404
TVB-4404
TVD-2403
TVD-4403
TVD-2404
TVD-4404
Programming
Once the camera hardware has been installed, the camera can then be
configured using the built-in OSD button or an OSD controller (purchased
separately).
You can also configure the camera settings via a TVI DVR, select PTZ protocol
as TruVision Coax and click the menu button to call the menu.
Note:
Interlogix offers two different versions of the OSD Controller: the TVS-C100
controller and the TVS-C200 controller. Please choose the corresponding
controller by referring to product datasheets.
The cameras listed in "Introduction" section support TruVision Coax OSD control
protocol and require the TVS-C200 for OSD control.
The TVS-C200 is used to program the camera's 960H CVBS output, not for the
TVI video output. Programming the camera's TVI output can be done via a TVI
DVR.
The TVS-C200 has four buttons for the camera functions selection and control.
Table 1 below lists the OSD control button functions and describes their use.
2
(1080P TVI Bullet Camera, Fixed Lens, IR, PAL)
(1080P TVI Bullet Camera, Fixed Lens, IR, NTSC)
(1080P TVI Bullet Camera, VF Lens, IR, PAL)
(1080P TVI Bullet Camera, VF Lens, IR, NTSC)
(1080P TVI Dome Camera, Fixed Lens, IR, PAL)
(1080P TVI Dome Camera, Fixed Lens, IR, NTSC)
(1080P TVI Mini Dome Camera, VF Lens, IR, PAL)
(1080P TVI Mini Dome Camera, VF Lens, IR, NTSC)
TruVision High Definition TVI Camera Configuration Manual