Hazard Warning Lights; Replacing A Bulb - Jeep Renegade Owner's Handbook Manual

HAZARD WARNING
LIGHTS
CONTROL
Press button fig. 105 to switch the
lights on/off.
When the hazard warning lights are on,
the and warning lights flash.
105
IMPORTANT The use of hazard warning
lights is governed by the highway
code of the country you are driving in:
comply with legal requirements.
Emergency braking
In the event of an emergency braking
the hazard warning lights switch on
automatically as well as warning lights
and in the instrument panel.
The lights switch off automatically when
emergency braking ceases.
124

REPLACING A BULB

133) 134) 135) 52)
GENERAL
INSTRUCTIONS
❒ Before replacing a bulb check the
contacts for oxidation;
❒ replace blown bulbs with others of
the same type and power;
❒ after replacing a headlight bulb,
always check its alignment;
❒ when a light is not working, check
that the corresponding fuse is intact
before replacing the bulb. For the
location of fuses, refer to the paragraph
"If a fuse blows" in this chapter.
J0A0050C
IMPORTANT When the weather is cold
or damp or after heavy rain or washing,
the surface of headlights or rear lights
may steam up and/or form drops of
condensation on the inside. This is
a natural phenomenon due to the
difference in temperature and humidity
between the inside and the outside
of the glass which does not indicate a
fault and does not compromise the
normal operation of lighting devices.
The mist disappears quickly when the
lights are turned on, starting from
the centre of the diffuser, extending
progressively towards the edges.