Jeep Renegade Owner's Handbook Manual page 138

❒ remove the fixing device for the jack
and the spare wheel;
❒ remove the wheel chock;
❒ remove the jack unit and the key for
removing the bolts from the spare
wheel. Turn the screw of the jack to
loosen the key and separate it from the
jack assembly;
❒ take the spare wheel out of the
luggage compartment.
Tool box (where provided)
On versions with spare wheel there
is also, inside the luggage compartment
(right side), a tool box secured to the
luggage compartment carpet with
dedicated fastenings.
Inside the tool box are fig. 133:
❒ A: the jack;
❒ B: the screwdriver;
❒ C: the emergency refuelling adaptor;
❒ D: the wheel locating pin (where
provided, to use during the spare wheel
fitting operation);
❒ E: special anti-theft nut (where
provided, to use during the wheel bolt
fitting/removal operation);
❒ F: a chock for locking the wheels;
❒ G: the tow hook;
❒ H: the key for removing/tightening the
wheel bolts and operating the jack;
136
❒ I: the Allen key for emergency sun
roof operation (where provided).
C
B
D
E
F
G
H
133
Important information about
the jack
Please note that:
❒ the weight of the jack is 2.8 kg;
❒ the jack requires no adjustment;
❒ the jack cannot be repaired: in the
event of a fault it must be replaced by
another original one;
❒ no tool other than its cranking device
may be fitted on the jack.
Then proceed as follows:
❒ should it be necessary to stop the
A
vehicle on a road with a gradient,
especially a very high one, or on an
unstable surface, take chock A and fold
it out, as shown in the diagram in fig.
134;
I
134
❒ alert any bystander that the vehicle is
about to be raised: all persons should
J0A0226C
be kept away from the vehicle and
nobody must touch it until it has been
lowered. Nor should any occupant
remain in the vehicle;
❒ if the vehicle has alloy wheels, where
the hub cap covers the bolts, use the
key with great care to remove the
hub cap before raising the vehicle;
J0A0157C