Main Circuit Breaker - Pride Mobility Victory XL-8 Owner's Manual

Main Circuit Breaker

When the voltage in your Victory XL-8’s batteries becomes low or your Scooter is heavily strained because of
excessive loads, the main circuit breaker may trip to protect your Victory XL-8’s motor and electronics from
damage.
When your Victory XL-8’s main circuit breaker trips, the reset button pops out and your Victory XL-8 shuts
down. (The main circuit breaker reset button is mounted on the upper rear section of your Victory XL-8, near the
charger power cord receptacle.) If the reset button pops out, perform the following steps.
1. Allow a minute or so for your Victory XL-8’s electronics to “rest.”
2. Push in the reset button to reset the breaker.
Motor/Transaxle Assembly
The motor/transaxle assembly consists of a geared transmission and differential. This one piece, direct drive, fully
sealed assembly provides quiet operation with maximum power and long life.
Charger Power Cord Receptacle
This receptacle enables you to plug the charger power cord into the Victory XL-8. For further details on using the
charger power cord, refer to V. “Batteries and Charging.”
Electronic Controller Module
This module is located behind the batteries and at the forward left corner of your Victory XL-8’s rear section. The
controller module receives electrical signals from the console controls and sends power to the motor, the brakes,
and the lighting system.
WARNING! Do not expose the electronic controller module to moisture. If it does become exposed
to moisture, do not attempt to operate your Victory XL-8 until it has thoroughly dried.
Anti-tip Wheels
The anti-tip wheels are an integral and important safety feature of your Victory XL-8 which prevent your Scooter
from tipping backwards on an incline. They are located at the rearmost part of your Scooter.
WARNING! Do not remove your Scooter’s anti-tip wheels or modify your Scooter in any way
that is not authorized by Pride Mobility Products, Ltd.
16
I V . D E S C R I P T I O N
Victory XL-8