Safety; Introduction; General Safety Regulations - Saeco NEXTAGE CAP010 Use And Maintenance

Automatic machine for espresso coffee and hot beverages
Hide thumbs Also See for NEXTAGE CAP010:
Table of Contents

Advertisement

English
3

SAFETY

3.1

Introduction

According to the low voltage Directive 2006/95/EC
(substituting
Directive
amendments) and the CE marking Directive 93/68/EEC,
SAECO VENDING has arranged for a NextAge technical
file at its premises, thus transposing the following
standards during the designing phase:
-
EN 55014
-
EN 6100-3-2
-
EN 61000-3-3
-
EN 61000-4-2
-
EN 61000-4-3
3.2

General safety regulations

It is forbidden to:
• disable the safety devices installed on the appliance;
• carry out maintenance on the
unplugging it first;
• Install the appliance outdoors. It is advisable to place it in a
dry place where the temperature does not drop below
1°C, in order to prevent any possible freezing.
• use the machine for purposes other than those indicated
in the sale contract and in this publication;
• connect the appliance to the mains using multi-sockets or
adapters;
• use water jets to clean the vending machine.
52
73/23/EEC
and
following
-
EN 61000-4-4
-
EN 61000-4-5
-
EN 61000-4-11
-
EN 60335-2-75
-
EN 60335-1
machine without
It is compulsory to:
• check the electrical power line for conformity;
• use original spare parts;
• read the instructions contained in this publication and in
the enclosed documents carefully;
• use personal protection devices during installation, testing
and maintenance operations;
• Use a new water network connection set each time the
machine is disconnected and connected again to the
system.
Precautions for preventing human errors:
• make the operators aware of safety issues;
• handle the machine, either packaged or unpackaged, in
safe conditions;
• have a thorough knowledge of the installation procedures,
its operation and limits;
• dismantle the machine in safe conditions, in accordance
with the environmental protection and health and safety
laws in force.
To prevent machining residues from coming into
contact with the beverages, dispense about 0.5 l water
for each dispensing path before definitely starting the
vending machine. The dispensed beverages can be
consumed only after performing this operation.
Do not install the appliance in a location where water
jets may be used.
The appliance must only be installed in places where it
can be used and maintained only by qualified staff.
In case of failure or malfunctioning, please refer only to
the qualified personnel of the technical service.
The Manufacturer declines any liability for any damage
caused to property or injury caused to persons as a
result of failure to observe the safety regulations
described here.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents