Honeywell Domonial User Manual page 9

How to use the wireless keypad with prox re a d e r *
④
The keypad is used to arm and to disarm your security
system using a valid access code or key TAG.
To use all the functions of the keypad you must have the master code
chosen during the installation or have the master key TAG.
Your system is equipped with a TAG prox reader: you can present
the TAG in front of the keypad in place of entering your code.
●
ARMING USING YOUR CODE OR TA G
✔ Press an arming key on the keypad and enter valid code
or present a programmed TAG.
4 Digit code
4 Digit code
4 Digit code
✔ A flashing red light on the keypad confirms that code is valid.
- The arming tone
siren followed by the exit delay beeps.
✔ Total set arming is completed after you close the final exit door. After the door is closed, exit
delay beeps stop and the arming complete tone is emitted by the panel siren.
✔ Part set or annex set arming is completed automatically at the end of the delay.
(Depends on site configuration)
Note:
✔ Always make sure that your arming request is followed by the arming tone.
✔ Always disarm the system when re-entering the premises.
NB: on some keypad models, presenting the TAG more than 2 seconds will arm the system without
pressing the Arm key.
* The system may include 0 to 4 keypads of this type.
Arms the total set
Arms the part set (See description p.13)
Arms the annex set
is emitted by the panel
9