Honeywell Domonial User Manual page 13

✔ Enter the master code or present the master TAG (user 1)
✔ Select and enter an existing single digit user ID (0-9)
✔ Present the new key TAG
✔ A double beep on the keypad will confirm that the new TAG is programmed and replace the
previous TAG if any.
Exit programming mode by pressing key.
WARNING : The system will automatically exit programming mode after 15 seconds if no
keys have been pressed and the red light will be timed off. If this occurs you must start this
process again from the beginning.
●
ADJUSTING BEEP LEVEL
The level of system tones emitted by the panel siren can be adjusted using the keypad.
To change the beep level of the panel siren, you need to enter programming mode
+
✔ Press key:
simultaneously
✔ The red light will flash slowly
✔ Press key
✔ Press
key
✔ Enter beep level: 1 to 7
✔ A double beep on the keypad will confirm that the beep level is changed.
Exit programming mode by pressing key.
13