Honeywell Domonial User Manual page 12

●
CHANGING OR SETTING ADDITIONAL CODES
The keypad can have up to 10 users. User 1 has the master code or master TAG.
To change or set additional user codes, you need to enter programming mode
+
✔ Press key :
✔ The red light will flash slowly
✔ Enter the master code or present the master TAG (user 1)
✔ Select and enter an existing or new single digit user ID (0-9)
(N.B. : User 1 is always the master)
✔ Enter the new code for this user
✔ A double beep on the keypad will confirm acceptance of the new code.
✔ You must confirm the new code by re entering it.
✔ A double beep on the keypad will confirm acceptance of the new code.
Exit programming mode by pressing
●
CHANGING OR SETTING ADDITIONAL KEY TAGS
A key TAG can only be programmed for a user who already has a code.
To change or set additional key TAGs, you need to enter programming mode
+
✔ Press key :
✔ The red light will flash slowly
simultaneously
key.
simultaneously
12