Connectors - ASROCK P4VT8+ User Manual

2.8 Connectors

FDD Connector
(33-pin FLOPPY1)
(see p.7 item 15)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connect the blue end
to the motherboard
Note: If you use only one IDE device on this motherboard, please set the IDE
Serial ATA Connectors
(SATA1: see p.7 item 12)
(SATA2: see p.7 item 11)
Serial ATA (SATA)
Data Cable
1 4
This Manual: http://www.manuallib.com/file/2595543
Connectors are NOT jumpers. DO NOT place jumper caps over
these connectors.
Pin1
connector.
Primary IDE Connector (Blue)
(39-pin IDE1, see p.7 item 8)
IDE1
PIN1
80-conductor ATA 66/100/133 cable
device as "Master". Please refer to the instruction of your IDE device vendor
for the details. Besides, to optimize compatibility and performance, please
connect your hard disk drive to the primary IDE connector (IDE1, blue) and
CD-ROM to the secondary IDE connector (IDE2, black).
FLOPPY1
Secondary IDE Connector (Black)
(39-pin IDE2, see p.7 item 7)
IDE2
PIN1
connect the black end
to the IDE devices
These two Serial ATA (SATA)
SATA2
connectors support SATA data
cables for internal storage
devices. The current SATA
SATA1
interface allows up to 1.5 Gb/s
data transfer rate.
Either end of the SATA data cable
can be connected to the SATA
hard disk or the SATA connector
on the motherboard.
the red-striped side to Pin1