Jumpers Setup - ASROCK P4VT8+ User Manual

2.7 Jumpers Setup

The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "Short". If no jumper cap
is placed on pins, the jumper is "Open". The
illustration shows a 3-pin jumper whose pin1
and pin2 are "Short" when jumper cap is
placed on these 2 pins.
Jumper
PS2_USB_PWR1
(see p.7 item 20)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided
by power supply.
JR1
(see p.7 item 27)
JL1
(see p.7 item 26)
Note: If the jumpers JL1 and JR1 are short, both the front panel and the rear panel
audio connectors can work.
CLRCMOS1
(see p.7 item 14)
Note: CLRCMOS1 allows you to clear the data in CMOS. The data in CMOS includes
system setup information such as system password, date, time, and system
setup parameters. To clear and reset the system parameters to default setup,
please turn off the computer and unplug the power cord, then use a jumper
cap to short the pins on CLRCMOS1 for 3 seconds. Please remember to
remove the jumper cap after clearing the CMOS.
This Manual: http://www.manuallib.com/file/2595543
Setting
2_3
1_2
+5VSB
+5V
JR1 JL1
Clear CMOS
2-pin jumper
Open
Short
Short pin2, pin3 to enable
+5VSB (standby) for PS/2
or USB wake up events.
1 3