Table of Contents
Advertisement
2.5 Installation of Memory Modules (DIMM)
P4VT8+ motherboard provides three 184-pin DDR (Double Data Rate) DIMM slots.
Step 1.
Unlock a DIMM slot by pressing the retaining clips outward.
Step 2.
Align a DIMM on the slot such that the notch on the DIMM matches the break
on the slot.
Step 3.
Firmly insert the DIMM into the slot until the retaining clips at both ends fully
snap back in place and the DIMM is properly seated.
This Manual: http://www.manuallib.com/file/2595543
Please make sure to disconnect power supply before adding or
removing DIMMs or the system components.
The DIMM only fits in one correct orientation.
It will cause permanent damage to the motherboard and the DIMM
if you force the DIMM into the slot at incorrect orientation.
notch
break
notch
break
1 1
Advertisement
Table of Contents
