Controls And Indicators; On/Alarm Silence/Manual Battery Test Button; Standby/Manual Bypass Button - Liebert GXT2-6000RTL630 User Manual

Liebert uninterruptible power supply owner's manual

Hide thumbs

Table Of Contents

Table of Contents

8.0

ONTROLS AND

8.1

ON/Alarm Silence/Manual Battery Test Button

This button controls output power to connected load(s) and has three functions:

• ON

• Alarm Silence

• Manual Battery Test

ON - Pressing this button will start up the UPS in order to provide conditioned and

protected power.

Alarm Silence - To silence alarms, press this button for at least one Second. After the

alarm is silenced, the GXT2-6000RTL630 will reactivate the alarm system to alert of

additional problems.

NOTE

The LOW BATTERY and BYPASS reminder alarms CANNOT be silenced.

Manual Battery Test - To initiate a manual battery test, press the ON button for at least one second

while operating from utility power with no alarm conditions present.

• If only three of the five Battery LEDs illuminate, allow the UPS to recharge the batteries for 24

hours.

• After 24 hours, retest the batteries.

• After the batteries have been retested, if only three of the five Battery LEDs illuminate, contact

your local dealer, Liebert representative or Liebert Worldwide Support Group.

8.2

Standby/Manual Bypass Button

This button controls output power to connected load(s) and has dual functions:

Standby and Manual Bypass.

NDICATORS

All indicators illuminated

for illustration only.

CAUTION

Pressing the Standby/Manual Bypass button once will transfer the

load to bypass power. Pressing the Standby/Manual Bypass button a

second time within 4 seconds will cut off power to the output

receptacles and connected loads. Perform all necessary shutdown

procedures on connected loads before pressing this button twice.

AC INPUT