Table of Contents
Advertisement
For PCI 2.1 Systems (or earlier 2.0 systems)
The 3-pin WOL connector (JP1) provides an interface to the PCI 2.1 compliant
system motherboard for auxiliary power and Power Management Enable signal
through the WOL cable. One 3-pin WOL connector must be also provided on the
motherboard. To install the cable, refer to section 2.2 for the details.
For PCI 2.2 Systems
JP1 WOL connector and WOL cable are not required. WOL feature is
accomplished through PCI 2.2 bus interface.
To support remote wake-up, the system motherboard must be fea-tured with RWU
or WOL support in hardware and BIOS. Refer to your system motherboard manual
to determine if it is remote wake-up capable.
Enable Adapter's Wake-On-LAN Function
The Wake-On-LAN function of the adapter is enabled with factory default setting.
RSET8139 program provided in the supplied driver diskette can be used to check
and set Wake-On-LAN configuration of the adapter.
Operating System Setup
In addition to the RWU-capable motherboard, an ACPI supported operating system,
such as Windows XP/ 2000/ ME/ 95/ 98 is also required to achieve RWU
functionality.
Advertisement
Table of Contents
