Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for KTI Networks KE-PCI/T
Summary of Contents for KTI Networks KE-PCI/T
- Page 1 KE-PCI/T, KE-PCI PCI Ethernet Card 10Mbps Full Duplex Plug and Play User’s Guide...
-
Page 2: Fcc Warning
FCC Warning This equipment has been tested and found to comply with the regulations for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated commercial environment. -
Page 3: Table Of Contents
Table of Contents INTRODUCTION..........1 PCI E THERNET ........1 RODUCT EATURES ......... 2 ACKING ............. 3 INSTALLATION............3 ARDWARE NSTALLATION ......3 ONFIGURATION ..........4 RIVER NSTALLATION ........4 ROM I NSTALLATION ......4 PRODUCT SPECIFICATIONS......5... -
Page 4: Introduction
Introduction Congratulations on your purchase of a PCI 10Mbps Ethernet adapter. This adapter was designed and manufactured to give you years of trouble-free and reliable service. PCI Ethernet Card Ethernet adapter high performance adapter compatible with version 2.0 of the PCI local bus specification and support Plug and Play (PnP) function, making it fully auto-configuration. -
Page 5: Product Features
Product Features Meets Local specification, Rev.2.0 PCI 32-bit architecture Compliant to IEEE 802.3 10BASE-2 and 10BASE-T standards. Supports PCI Plug and Play configuration. Supports Full-Duplex Ethernet function to double channel bandwidth. Automatic port selection between 10BASE-2 interface(BNC) and 10BASE-T interface(RJ-45) Support 100ohm STP/UTP cables using Category 3, 4 or 5 On-board socket for remote Boot ROM. -
Page 6: Packing List
Packing List The adapter package should contain the following items: One 32-bit PCI Ethernet adapter This User’s guide One 3.5” driver diskette One T-connector (for BNC port only) If any of these items are missing contact your reseller. Installation Hardware Installation Turn OFF the computer, unplug the power cord and open the computer case. -
Page 7: Configuration
Configuration This Ethernet adapter automatically configured when you power-on computer. In certain computer, however, you must modify BIOS by entering CMOS SETUP utility to enable “PCI Device” and map INTA to an appropriate address. Please refer to the system documentation details configuration the PCI SYSTEM BIOS. -
Page 8: Product Specifications
Product Specifications Standards IEEE 10BASE-2, 10BASE-T PCI Local Bus specification Rev.2.1 Wiring connector BNC and RJ-45 Bus Interface 32-bit PCI bus I/O address Automatically determined by configuration space IRQ Line INTA, being assigned by the BIOS to free I/O address Operating 0 °C –...