Table of Contents
Advertisement
2.3 Connecting to the Network
The rear bracket of the Fast Ethernet adapter contains two fiber connectors. The
connector labeled "TX" is used for transmission and the other one labeled "RX" is
used for reception.
Network Connectors
When connecting to a 100BASE-FX device using fiber cable, make sure the TX
connector of the adapter is connected to the RX con-nector of the device and RX
connector is connected to the TX connector of the device.
In order to have a reliable communication between two ends, the speed and duplex
configuration of the adapter's FX port and the device at the remote end must be
same. Configure the driver of the adapter as follows:
Link/Speed Setup
Auto Mode
100M_Half
Other settings are not suggested.
Connecting 100BASE-FX Fiber Cable
100BASE-FX Connection
100Mbps, Full duplex
100Mbps, Half duplex
Advertisement
Table of Contents
