Configuring Wake-On-Lan - KTI Networks KF-221FX series Installation Manual

2.2 Configuring Wake-On-LAN

If your system is a PCI 2.2 complaint system, no extra installation for WOL is
required. The WOL interface is accomplished through the PCI bus interface
directly.
If your system is a PCI 2.1 complaint system, follow these steps:
1. Make sure your system motherboard is RWU capable.
2. Make sure WOL function is enabled in the system BIOS.
3. Locate the 3-Pin WOL connector on the system motherboard.
4. Plug one end of the WOL cable to the 3-Pin WOL connector of the adapter.
5. Plug the other end of the WOL cable to the 3-Pin WOL connector on the
system motherboard.
Installing WOL Cable
Note:
The adapter provides PME signal with high active level. Make sure PME setting in
BIOS options is properly set if it is available.