High Pressure Pump Cover: Removal; Front Cover: Removal; Front Cover: Dowel Locations - Ford 6.0L POWER STROKE Service Procedures And General Diagnostics

U N I Q U E S E R V I C E P R O C E D U R E S

High Pressure Pump Cover: Removal

• After removing the bolts that hold the high
pressure pump cover to the crankcase, pull
the cover straight up to disengage it from
the high pressure pump discharge tube.
• When reinstalling the cover, be sure to
lubricate the discharge tube o-ring before
installing the cover.

Front Cover: Removal

• The point were the crankcase and main
bearing carrier meet, is sealed to the front
cover gasket with a dab of RTV sealant that
must be cut to remove the front cover
gasket.

Front Cover: Dowel Locations

• The front cover is located to the crankcase
with dowels.
• Note: If the dowels are missing or
damaged the front cover could be
misaligned and damage to the cover or
oil pump could result.
76
HIGH PRESSURE
HIGH PRESSURE
PUMP COVER
PUMP COVER
DISCHARGE TUBE DISCHARGE TUBE
CUT AT THESE TWO PLACES
CUT AT THESE TWO PLACES
O-RING
152
153
DOWELS DOWELS
154