Mounting And Installation - Elation E Spot LED User Manual

6. MOUNTING AND INSTALLATION

Cautions:
For added protection mount the fixtures in areas outside walking paths, seating areas, or in
areas were the fixture might be reached by unauthorized personal.
Before mounting the fixture to any surface, make sure that the installation area can hold a
minimum point load of 10 times the device' s weight.
Fixture installation must always be secured with a secondary safety attachment, such as an
appropriate safety cable.
Never stand directly below the device when mounting, removing, or servicing the fixture.
Mounting
The E Spot LED
upside-down from a ceiling, or set on a flat level surface (see illustration on the next page).
Never mount the fixture on its' side in any type of installation. Be sure this fixture is kept at
least 0.5m (1.5 feet) away from any flammable materials (decoration etc.). Always use and
install the supplied safety cable as a safety measure to prevent accidental damage and/or
injury in the event the clamp fails.
©Elation Professional, Los Angeles Ca.
Caution!
When install the fixture be sure there is no highly inflammable
material within a distance of .5m (1.5 feet)
™
is fully operational in two different mounting positions, hanging
Refer to regulations BGV C1 (formerly VBG 70) and DIN VDE0711-217
for proper installation in Europe To ensure proper installation, only
qualified staff should attempt installation.
12
E SPOT LED™
www.ElationLighting.com