Elation E Spot LED User Manual page 32

The calibration password is " C050." Use the UP or DOWN buttons to enter the
proper password.
5. Once the proper password is entered the display will read " CHXX" , were as " XX"
represents the fixture channel number, in the case of the E Spot Led™ 1 ~ 16.
6. Select the desired channel to be calibrated by pressing the UP or DOWN buttons
and then ENTER to confirm.
7. The display will then read " xxxx" , were " xxxx" stands for the calibrate value s.
8. Adjust the desired calibration value between – 128 and 127 by pressing the UP
and DOWN. As you scroll up and down through the calibration values you will
notice slight changes in the wheel or motor you are attempting to calibrate.
9. Once you reach your desired calibration press ENTER to confirm and lock in your
calibration.
13. EDIT MENU
- This menu item allows you to write a program into the fixture' s internal memory
(EEPROM) via the control panel or via an external DMX controller. For more information on
using the built-in DMX controller see " Working with Built-In Programs," Section 11 / Page 38.
SEPR- Select program to be edit.
STEP (S-01 - S-48) - These are the steps slots that you write your programs into. There
are at total of 48 steps.
STXX (SC01 – SC48) - These are the scenes that are stored in your program. There are a
total of 48 scenes. C-01 - C-11 (Channel 1 - Channel 11) – Represents the total fixture
channels for each scene that can be edited.
TIME (Time) - Running time of the entire program.
CEDT - Edit program using a external controller.
REC – Auto save function.
RUN – Program test mode.
REC
- Records scenes automatically from any external DMX controller and stores them
inside the fixtures built-in memory. These scenes can then be recalled without the use of
an external controller.
©Elation Professional, Los Angeles Ca. 32
E SPOT LED™
www.ElationLighting.com