Problems With The Load Size Indicator - Miele WT 2780 WPM Operating Instructions Manual

Problem solving guide

Problems with the load size indicator

Problem
The display indicates
a load of <25% or no
load size is indicated
when the drum is full.
The display indicates
a load greater than
<25% when the drum
is empty.
The following will
appear in the display:
Zero setting not possible.
Open the door
The drying
programme stops and
the following
message appears in
the display:
Check load
At the end of a drying
programme the
following message
appears in the
display:
Check load
58
Possible cause
Laundry was left in
the drum when the
machine was
switched off. This
has decalibrated the
sensor from the zero
setting.
The load sensor has
to be recalibrated to
zero after running
the Rinse out fluff
programme.
The load size sensor
has been
decalibrated from
the zero setting.
The drum door is
closed.
There is very little or no
laundry in the drum. Drying
individual garments or items
which are already dry can
also cause the programme
to be cancelled.
The machine has recognised
an overload.
Remedy
To recalibrate the sensor to the
zero setting:
– Remove the laundry from the
drum.
– Switch off the machine and
leave the door open.
– Switch on the machine.
– Turn the programme selector
to Cottons.
– Press and hold the Load % /
Detergent % button in until the
following message appears in
the display:
Zero setting OK
Rotate the drum once. If the
display still indicates a load
greater than <25%, recalibrate
the sensor to zero again (see
above section).
– Open the drum door.
– Recalibrate the sensor to zero
again.
In future, use a timed
drying programme or the
Warm air timed drying
programme for individual
items.
In future, do not exceed
the maximum load.