After Each Washing Or Drying Programme - Miele WT 2780 WPM Operating Instructions Manual

WASHING AND DRYING
D Load the drum
^ Open the drum door and load the
laundry loosely in the drum.
Follow the load size indicator and do
not overload.
Do not use detergent dispensing
aids, e.g. plastic dispenser balls, for
washing followed immediately by the
drying programme. These
dispensers can melt during the
drying programme and cause
damage to the machine and the
laundry.
E Close the drum door
F Add detergent
Follow the detergent percentage
display.
G Start the programme
^ Press the Start/Stop button.
H Remove the laundry when the
programme has finished
^ Turn the programme selector to the
Stop position.
^ Open the drum door and remove the
laundry.
See "After each washing or drying
programme" for further information.
48
After each washing or drying
programme
^ Open the drum door fully.
,
Caution, the metal cap located
on the inside of the door glass is
very hot after drying. Do not touch
it. It will be hot. Danger of burning!
^ Remove the laundry.
^ Check the folds in the door seal for
any small articles, e.g. buttons, which
might be lodged there. Remove any
fluff remaining from around the door
seal and porthole glass after drying.
Check that all items have been
removed from the drum. Items left
behind could colour run, shrink or
be damaged in the next washing or
drying programme.
Important: Always remove the
laundry before switching the machine
off. This is important to ensure that
the load size indicator works
correctly.
^ Switch the machine off using the
On/Off button K.
To avoid the build-up of mildew, it is
recommended that the door is left
ajar when the machine is not in use.