Miele WT 2780 WPM Operating Instructions Manual page 38

DRYING
D Load the washer-dryer
^ Open the drum door.
^ Load the laundry loosely into the
drum.
Do not overload the drum. See the
drying "Programme chart" for
recommended loads for each
programme. Overloading can cause
unnecessary wear and tear to the
laundry and give a disappointing
drying result.
E Close the door
Make sure that no garments are
caught between the drum door and
seal.
Make sure that objects e.g.
detergent dispensing balls have
been removed from the laundry.
They could melt and cause damage
to the dryer or the laundry.
The tap for the inlet hose must be
turned on, even when drying.
F Start the programme
^ Press the flashing Start/Stop button.
The estimated programme duration will
appear in the display.The electronics
continually assess the residual moisture
content of the laundry and adjust the
estimated time remaining for a more
accurate reading. Because of this, the
time displayed can alter during the
course of a programme. The time left
will count down by the minute in the
38
display.
The programme sequence and the
drying level reached will also be shown
in the display.
G Remove the laundry when the
programme has finished.
The Anti-crease phase starts as soon
as the programme finishes.
The machine will switch off
automatically 15 minutes after the
end of the Anti-crease phase. Push
the K button to switch the machine
back on.
^ Turn the programme selector to Stop.
^ Open the drum door and remove the
laundry.
Check that all items have been
removed from the drum. If items are
left in the dryer, they could be
damaged by overdrying when the
dryer is next used.
Important! Always remove the
laundry before switching the machine
off. This is important to ensure that
the load size indicator works
correctly.
^ Switch off the washer-dryer.
For more information, see "Washing
and drying - After each washing or
drying programme".