A Fault Message Appears In The Display - Miele WT 2780 WPM Operating Instructions Manual

A fault message appears in the display

Message
Fault
Check drainage
2
system
Fault
Water intake
2
Open stopcock
Waterproof system
activated
L
Close the stopcock
Technical fault
Call Service.
;
Chk detergent
A To remove the message from the display, switch the machine off using the
On/Off button K.
Possible cause
– The water outlet is
blocked or
restricted.
– The drain hose has
been fixed too high.
The water inlet is
blocked or restricted.
The water protection
system has reacted.
There is a fault.
Excessive foam has
built up during
washing.
Problem solving guide
Remedy A
– Clean the drain filter and
the drain pump as
described in "Problem
solving guide – Opening
the drum door in the
event of a blocked drain
outlet and/or power
failure".
– The maximum drain
height is 1 m.
Check whether
– the tap is opened wide
enough.
– the inlet hose is kinked.
– If the fault indicator
occurs again, contact
Miele.
– Close the tap.
– Call Miele.
Start the programme again.
If the fault message
appears again, contact
Miele.
Use less detergent next
time and follow the
manufacturer's instructions
on dosage given on the
packaging.
57